5 Steps to Safely Clean and Lubricate Your Motorcycle Chain

Declan Constable
Published: 5 May 2023

Chain maintenance is a vital part of looking after and maintaining your motorcycle, it is the piece that connects the rear wheel to the engine, and without one, you may find yourself unable to move on your motorcycle.

Keeping it lubricated and looked after will work to increase its lifespan, help you get more miles out of it, and increase the lifespan of the chain and sprockets. The total process should take under 20 minutes.

Here are the steps you should follow to lubricate your chain.

Position the motorcycle

If you have access to a paddock stand or your motorcycle has a centre stand, it will make this process a lot easier, but this isn’t a necessity and can be done without one, but you’ll need to do a little bit of walking and moving your motorcycle around.

Putting it onto the centre stand or a paddock stand in neutral will allow the rear wheel to spin freely, meaning the wheel can be spun, cleaned, lubricated, and then spun again.

Scrub the chain

Begin to spray chain cleaner onto the chain where it lies on the rear sprocket, make sure to coat the entire chain, and then, using a chain cleaning brush, begin to scrub off any dirt or grime that you may see.

Once coated and scrubbed, spin the wheel again to continue the process. If your bike is on a paddock stand, you can simply spin the wheel; if you are using the kickstand, you can try to tilt the bike over slightly to spin the wheel, or simply push the bike forward into a new position, allowing you to clean the chain.

Continue to clean and scrub until the entire chain has been cleaned.

It’s important you do not try to put the bike into gear and scrub and clean by holding the brush in place; although it may be faster and more effective, you risk losing fingers and causing serious injury if your hand gets caught between the chain and the sprocket.

Time to clean up

Once the chain has been cleaned, clean off the chain using water before wiping it dry. You can use chain cleaner to remove any overspray that may be sitting on the back wheel or sprockets.

Go for a ride!

Probably the best part of the process is going for a quick ride no longer than 15 minutes to warm up the chain and remove any additional water that may be sitting dormant after cleaning the chain, this will allow the chain to be in prime condition for lubrication.

It’s lubin’ time!

Return the motorcycle to the paddock stands once the chain has been thoroughly warmed up and is in an ideal state to be lubricated. Next, spray the underside of the chain for one full spin using the lubricant.

The next step is to go around the chain a second time, but this time you should spray the chain’s inner side. After that, you should go around the chain one more time to cover the chain’s outer side.

It is important not to use too much lubricant, so it is best to spray lightly and carefully.

Finally, check the tension of the chain and adjust it if necessary.